iPhone5 confirm the aluminum back cover Lumia 900 exposed a new low

iPhone5 ultimately confirmed the use of aluminum alloy back cover

Recently in the news online, have pointed out the new iPhone will not be published in the WWDC 2012, we may be disappointed. The network one after another outgoing suspected spy photos of the new iPhone, and even take the picture parameters suspected shell with the iPhone (Review) S video. This shows that the iOS, the new Macbook Pro so can not satisfy everyone's appetite, the most talked about Apple products, or the new iPhone. Just today, a reliable news source to love the range of children to confirm the specifications of the new iPhone, confirms the previous rumors.

Prior to the release by 9to5mac come two new iPhone from an Apple supplier back shell, we made ​​before the relevant reports, and it listed with the iPhone 4S change:

Aluminum alloy back panel, but not before rumors of the liquid metal;

Back microphone for noise reduction and video recording, and also between the lens and the flash point;

Shrink the Dock interface, it looks like the MicroUSB, and finally is no longer the old 30-pin;

Headphone port on the bottom, like the iPod Touch; the bottom of the speaker and microphone openings become similar to the N9 and the HTC One X drilling design, but the hole is fairly thick, the shell of the leak is the most suspicious place;

Longer screen, probably before rumors of the 3.999-inch 16:9 display with a resolution of 1136 × 640. Such a design can guarantee the same width of the screen, the same horizontal resolution to maintain a certain compatibility.

The above hardware information is credible. The next generation iPhone will be made ​​of aluminum alloy shell, screen resolution and size are related to the conjecture.

On the aluminum alloy shell, the sources said the new iPhone and new iPod touch shell will use this material, and if we think first about feelings feel the words of Apple's old iPod Mini can find out the touch, itthe shell material with the new iPhone is almost the same news source called the iPod Mini rebirth. In addition, this aluminum alloy shell program before it is finalized, the shell of the new iPhone has never been considered widely rumored that the liquid metal before use.

In the photograph, we can see the back of the shell was divided into three sections, a large area in the middle by aluminum alloy composition, the smaller parts up and down the glass, informed sources said the new iPhone's front will continue to is a single piece of glass panels. Also revealed that the upper and lower ends of the back cover had tried using an enhanced ceramic production, while the use of strengthening ceramics produced by the new iPhone prototype not only feel and body hardness class, and there is no kind of thick ceramic people think Influenza (Japan Kyocera ceramic production technology advanced). But in the end do not know Apple for what to consider strengthening the ceramics program was abandoned, as with the iPhone 4S glass has become the ultimate choice.

The new iPhone has not been put into mass production, the sources said the problem lies in the aluminum alloy shell lower part of the new interface, we can see from the traditional 30-pin connector replaced by a unified industry pushing MicroUSB. Interface to adjust the overall design of a device should not focus, but it is learned in the production of the new iPhone, the interface appeared the problem, as long as this issue is resolved, the new iPhone will be able to mass production.